Bicast Sticky Leather Cleaner 1.5

Bicast Sticky Leather Cleaner 1.5 by Leather Doctor is a pH 1.5 balanced cleaner to remove sweat and alkalinity to prevent it from becoming sticky and flaking.

Bicast 1.5 is formulated to work with Leather Degreaser 2.2, Leather Acidifier 2.0, and Leather Protector B in a holistic system to solve and control leather sticky problems.

A fresh coating of Topcoat 76G with Crosslinker 64 is a permanent solution to terminate this sticky issue.

A flaking refinishing will require a sequence of processes starting from Leather Stripper 2.3, Leather Acidifier 2.0, Leather Adhesor 73, Leather Pigment 54, Leather Topcoat 54, Leather Crosslinker 64 and ends with Leather Protector B.

People Also Ask:

1: How to Use Bicast 1.5 to Control Mild Leather Stickiness?

2: What is the Cause of Bicast Leather becoming Sticky?

3: How to Rectify Sticky Bicast Leather?

4: What is the Working System of Bicast 1.5?

5: How to Restore the Deteriorating Sticky Finishes?
.

1: How to Use Bicast 1.5 to Control Mild Leather Stickiness?

1.1: Concentrate ratio 1: 12 (Add 210g distilled water before use).

1.2: Apply Bicast 1.5 and brush with Leather Brush 1 to remove surface soiling and towel extract until the towel shows clean.

1.3: Apply Acidifier 2.0 and brush with Leather Brush 1, let a few minutes dwell to pH balance potential stickiness and towel extract until the towel shows clean.

1.4: Let dry, and inspect with hand to check for stickiness, if stickiness has improved and a temporary solution suffices, Protector B non-stick protection may end this temporary problem.

2: What is the Cause of Bicast Leather becoming Sticky?

2.1 Sticky Bicast leather is mainly the result of accumulated body oil, grease, and sweat; long storage; exposure to inert gases; and further alkaline cleaners, incompatible oils, and conditioners often compound it.

3: How to Rectify Sticky Bicast Leather?

3.1: Sticky Bicast leather is rectified with Bicast 1.5 with its low pH value of 1.5 to tighten up the swelling of the urethane finishes at the molecular level thus reducing the stickiness.

4: What is the Working System of Bicast 1.5?

Bicast 1.5 works with Degreaser 2.2 to remove the stuck fabric and complimentary Acidifier 2.0 as a rinse reinforce the working effect.

5: How to Restore the Deteriorating Sticky Finishes?

5.1: The surface is inspected and tested for satisfaction. Protector B a non-stick protector ends the temporary sticky rectification process.

5.2: In extreme cases where stickiness persists, refinishing the urethane topcoat with Bicast 76G and Crosslinker 64 as a hardener is highly recommended to end the sticky problem.

5.3: Protector B imparts a non-stick surface to help reduce potential stickiness.

Your opinions and insights are precious and will help us to improve our writing and communication to solve your leather problem more efficiently.

Edited June 26, 2024, by Roger Koh.