Product Overview
Leather Aniline Wax Pull-up Tarnish Stain Remover - Kit-Aw5.hs by Leather Doctor is designed to remove practically most stains that derive from metal including the rusty stain after the protein component of the blood is removed. d’Tarnish-1.3 works by chemical reaction dwelling with a paper towel until it is naturally dry for the product to take effect. Basifier-8.8 neutralizes the low pH with the same dwelling technique and repeat to let dry naturally as well. Hydrator-3.3 relaxes stiff leather and reduces surface tension for an even appearance prior to fat and oil replenishing. Fatliquor-5.0 replenishing rejuvenates the leather structure for suppleness when dry. Wax Effect-8.6 rejuvenates the structural wax pull-up effect and coagulates a cloudy waxy coating on the surface to be heat activated into the characteristic glossy sheen. The surface wear of the leather is greatly reduced with a rub-resistant Protector-D+ that enhances a non-stick draggy-feel to shield against sticky soiling, besides healing and concealing lightening scuff and abrasion marks. Note that the mentioned products suffix numbers denotes its pH value in this holistic approach to removing metal derived from aniline wax pull-up leathers.
Instruction
Stain Removal
1. Apply d’Tanish-1.3 onto the stain, agitate with horsehair Brush-1 and towel extract until it shows clean.
2. Soak the remaining stain with a saturated paper towel until natural dry for product reaction.
3. When the stain vanished, neutralize with Basifier-8.8 by applying and letting it dwell until natural dry.
Hydrating
1. Hydrator-3.3 is applied to plumps the leather and prepares the surface for an even appearance prior to fat and oil replenishing.
Fat and Oil Replenishing
1. Spray Fatliquor-5.0 and redistribute evenly with foam brush until fully saturated.
2. Repeat reapplication when water content evaporates until fully saturated.
3. Let natural dry for extra softness and wick up soiling particulates is brushed when crispy dry.
Wax Effect Rejuvenating
1. Shake well, spray Wax Effect-8.6, spread evenly with brush or towel and leave natural dry until wax crystal forms on the surface to be heat activated with heat blower or hair dryer to a glossy sheen.
Rub-Resistant Protection
1. Mist sprays Protector-D+ redistribute with a paper towel and ready for use when dry.
Kit Content and Product Description:
Leather Doctor® d’Tarnish-1.3 (30ml)
This is a waterbased pH 1.3 leather tarnish remover. It is for removing metallic stains like rust and tarnish.
Leather Doctor® Basifier-8.8 (250ml)
This is a waterbased pH 8.8 mild leather basifier. It is to neutralize strong acidic exposure especially after d’Tarnish-1.3.
Leather Doctor® Hydrator-3.3 (250ml)
This is a waterbased pH 3.3 leather-safe hydrator with active surfactantcy for lowering the interfacial tension. It is for hydrating dried, stiffed or shrunk leathers to separates the crushed, stick together fibrils and relaxes them. It is for charging the leather protein fibers below its iso-electric point positive for long lasting hydrogen bond with the ionic negative charged Fatliquor-5.0. It is for facilitating colloidal water movement within the leather structure during the wicking process to move soiling particulates to the surface.
Leather Doctor® Fatliquor-5.0 (250ml)
This is a pH 5.0 anionic charged micro emulsion fatliquor to season and rejuvenate leather with softness, suppleness and strength. It is for replenishing original fat and oil that diminishes thru sun-tanning, ageing, heat and alkaline exposure or cleaning. It penetrates and lubricates the leather fibers so that after drying they will be capable of sliding over one another smoothly. It softens the leather with stretchability, compressibility and flexibility, while enhancing its rip tensile strength greatly. It relaxes coarse breaks, creases and wrinkles enhance suppleness and prevent cracking. It helps to keep leather at its optimum physical performance and prevent premature ageing.
Leather Doctor® Wax Effect-8.6
This is a pH 8.6 waterbased emulsion wax-effect leather rejuvenator.
It is to rejuvenate wax pull-up effect diminished through usage, ageing or cleaning.
Leather Doctor® Protector-D+ (120ml)
This is a non-film forming, non-stick rub-resistant protector that enhances a draggy-feel with a classic leather scent. It imparts a non-stick breathable barrier essentially to shield the detrimental effects of sticky soiling. Its natural draggy-feel protection increases the leather resistance to wet and dry rubs, thus reduce stretch, scuff and abrasion. It is used as a scuff repairer, filling and concealing surface scuffs to improve appearance.
Leather Brush-1 (1pc)
This horsehair detailing brush is designed ergonomically to be an extension of our hand with a sturdy grooved grip. It is designed to produce effective result easily and efficiently. It is recommended for all smooth leather for a soft and scratch-free cleaning. Its length is 7 inches with a three-row bristle 1½ inches cleaning head.
3 inch Poly-Brush (1 pc)
This is a dense foam that resists tearing and shredding and carries more material. It has a solid wood handle that allows greater control for quality results. It is used for controlling and spreading fatliquor for a more even distribution.
Paper Towel Rags (5 pcs)
This rag works like cloth, lint free, highly absorbent and washable. General application is for extracting suspended soiling or for spreading hydrator, fatliquor or protector. It is used for both dye and topcoat padding for smooth leathers.